Modded stock VFC MP5 nozzle - Day 1
Modded the stock nozzle:
A ) Shortened the nozzle head by 0.5mm to prevent chipping.
B ) Inserted a centimeter long nail into the tip of the feedramp to act as an integrated metallic insert
- A 1mm hole/bore, 1cm in length was first drilled into the feedramp
- A 2mm taper at the tip for the nail head
- The Nail (slightly wider than the 1mm bore) was then melted into the hole using a soldering iron touching on the nail and pushing it into the bore.
- The head was then filed down flat to the same level as the feed ramp surface.
Will see how long this lasts.
Recommended Comments
There are no comments to display.