PGC SFA
Here is my third PGC build. Built for a client who wanted a full metal 1911, this one was actually fairly easy. No real problems, just the usual fitting and testing. These new PGC bodies for the TM 1911 are great. This was good for me since I wanted to check out the front sight on the SFA to decide if I wanted to build one for myself. I prefer the slant on the Delta kit myself.
Ran into a little problem with all the PDI 6.01mm tight bore being out of stock, but the Nine Ball is a close second. In the end I liked the gun, and the work must have been good enough, I am spec-ing a new Hi Capa for the same client.
TM M1911A1
PGC SFA Body
PGC Outer Barrel
PGC Recoil Spring
Nine Ball Dyna Piston
Nine Ball 6.03mm Tight Bore
KM Stainless Steel Hammer Strut
Recommended Comments
There are no comments to display.