muckymick

good job the main rail is two pieces and the tri rail bit allow's it to be axtended to fit longer/shorter receivers. not sure why they made it that way but it is also sold as fitting siaga shotguns, is that receiver longer than an ak47 receiver. My main concern was it not fitting into the rear site holder on an airsoft receiver.

Has anybody tried fitting one of these to an airsoft AK as i ordered one and think i may have boo booed http://www.ebay.co.uk/itm/New-AK-Tri-Rail-Scope-Mount-Side-Rails-Flashlights-Lasers-MK002T-/230725927286?pt=LH_DefaultDomain_0&hash=item35b8564176

when i first got mine the bb's did fall through the hop up and out the barrel so i took the barrel and hop unit apart to find that the barrel was upside down and the hop rubber was fitted in the hop chamber wrong.I reasembled it correctly , now every thing work as it should and the bb's no longer fall out the barrel

Davester00 thank's for the link, sent them an email so hopfully they'll be able to help me out. thank's

Hi . I have a ksc usp compact and i have snapped the trigger ,does any body know were i can get a replacement as i can't seem to find one in the usual places. Thank's

fellowz i've sent you a pm regarding the parts your after should be able to sort you out

brill never thought about tears of the sun film ,but will watch it again for some insperation ,not to keen on all that molle stuff my self ,thanks for the help

would this be a good bdu set to match that vest as i can't seem to find any pics of load out to get any ideas from bdu's thanks for letting me know what i have bought just need a little help sorting out what this would look good with

help i got this vest from gunner's and it is good and does every thing i need but who in the real world services would use this and what sort of load out and uniform would they were vestthingy

any body know if their is a body kit to change a g36 into one of these linky i think it a mexican knock off of a g36

This has given me the urge to sort my stuff as i have aeg's every were i keep tripping over some of them The peg board that some of you have used where is a good place to buy this from and is it expencive?

i got the micro switch from this company http://uk.rs-online.com/web/ but it keeps giving me some error screen when i try and find the page the switch is on i will dig the invoice out so i can get the part no for you

i have rewired my ak 249 para and replaced the fuse and holder to the blade type used for cars ,replaced the micro switch with a high temp one rated at 30amp which i got from rs components and run mine on a 11.1v 2200mah li-poly battery which is still located in the hand gaurd.It has been like this for about two months now and has had about 25 000 bbs through it with now problems

strip the internals on the mag,2 screws on the bottom and 2 near the top .their is a brass feed pipe coming from the feed mechanism pull this out and check that no bbs are jammed in their

the motor on my gearbox has burnt out but the rest of the gearbox is ok .any body know what type and make of motor i should replace this with