Jump to content

julietcharlie

Members
  • Content Count

    71
  • Joined

  • Last visited

About julietcharlie

  • Rank
    Adv Member

Additional Information

  • Airsofter since
    2006
  • Country
    Philippines

Profile Information

  • Gender
    Male
  • Location
    MNL
  1. I just bought a couple CO2 mags and I am in the process of looking for leaks, I installed the capsules last night and gas is still there this morning so far so good.
  2. Yup those are gen 1 mags alright. I'd use it for 134a only if I still have them, all 3 of my gen 1 mags are gonners.
  3. L33, can you verify if there is no spacer under the rubber seal by removing the mag lip?
  4. but the spacer prevents the bolt from travelling too far back the buffer tube
  5. Same with an M4 buffer without the spacer your bolt will get stuck in the buffer tube.
  6. Hmmm, this is intruiging and I just ordered the stinger kit, I hope this new hop will be a lot better than anything out there.
  7. I remember that project of yours and was thinking of making one myself. Unfortunately I can't take my gun out before May so I guess we can't test the TS-19 with your home brew non-rotating op-rod.
  8. I'm using GG and I average at 375 fps on 0.3g. My initial testing with 2 mag fills only, first shot with full gas at 415 fps and leveled of at 375 ave. after about 5 shots with 10 sec interval I can get a deviation as small as 0.5 fps with a few 10 fps deviations once in a while. Rapid firing I guess would yield maximum deviations of around 20 fps, but not really sure since my chrono can't reset as fast as my trigger finger.
  9. It was the same reason I got the CO2 kit I thought it will give me better consistency. Now talking about muzzle velocity consitency I just got myself a TSC loading nozzle TS-19 and it does work very well.
  10. mnmc, maybe we can modify the pin by rounding off the top portion instead of cutting it diagonal. In addition to the pin I have a small rubber pad (cut from a spare AEG piston head o-ring) under the pin so the arrangement goes like this; from the top - pin, small rubber pad and hop-up rubber. I get better results than stock set-up but I still need a few more adjustment to come to upgraded AEG precision standard.
  11. I see, I do have an all TSC trigger group and I do get an intermittent un-commanded discharge in semi when I release the trigger just after a shot. I thought the trigger to hammer contact surface is too small to catch the hammer after the semi auto sear is released. I'll try doing that and see if it will help. thanks HFC22, nice to see you here and thanks to your magazine work I have a leak free GG mags. I also tried sanding my black v.2 hop up rubber but I still need to do some test.
  12. Can you elaborate the modification on the contact surface pictures would really help, thanks
  13. Your trigger and/or hammer is already worn out, happened to mine too switched to TSC steel trigger group.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.