Jump to content


  • Content Count

  • Joined

  • Last visited

Everything posted by ninja828

  1. ninja828

    G&P GBB M4A1 family

    The four that my friends and I purchased don't...in three different WOCs too. They'll either first fire in semi properly, then a burst then vent or vent the entire reservoir on full auto and that's only if they fire. With the mags inserted in my WOC (stock BC and nozzle), tried it w/ the stock and a stronger hammer spring, did the fix prowin suggested and it looks like the hammer isn't even depressing the valve anymore. I double checked this w/ the upper receiver off and instead of it venting all the gas on semi as w/ my other working mags, I just get a slight puff noise, no significant gas expulsion...any ideas?
  2. ninja828

    VFC KAC PDW Review

    You see that triangular metal plate right above the trigger in that pic? You bend the center piece away from the body slighty then slide the metal plate towards the rear of the body. There's another pin that you will see that holds the gb in place (it's the pin at left-most part of the triangular metal plate in the pic above the trigger) just pop that out then you're done! Took me a while of fidgeting to completely disassemble too
  3. ninja828

    VFC KAC PDW Review

    Ukau is using a 11.1v 900mah lipo to whom the question was initially intended for, guess I should've specified uscmCorps: Your PDW looks so clean w/o a PEQ box! Lucky!
  4. ninja828

    VFC KAC PDW Review

    Have you switched out that aluminum piston head yet? Especially since you're running a li-po?
  5. ninja828

    VFC KAC PDW Review

    How's the mosfet situation look? I couldn't imagine running a li-po on any aeg, even the PDW, w/o a moseft unless I wanted crispy contacts after a day of use...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.