Krazeh
Members-
Content Count
60 -
Joined
-
Last visited
About Krazeh
-
Rank
Adv Member
Additional Information
-
Airsofter since
2011
-
Country
United Kingdom
Profile Information
-
Gender
Male
-
Location
Manchester
-
With mine I just had to rack the slide back. Altho the slide release lever appears to turn fine now whether the slide is racked back or not.
-
Got it from Eagle6. They had a few spare from an order they'd made, dunno if they have any left now tho.
-
Had this show up this morning: Feels a little light compared to my PX4 but very solid. Also love the finish they've done on the slide. Can't wait to try it out at a skirmish.
-
BTC V2 Spectre FET First Impressions
Krazeh replied to aznriptide859's topic in Tactical Equipment and Accessories
You would probably need to desolder the existing wires, but it should be possible. -
Initial Impressions of the TM PX4 GBB Pistol
Krazeh replied to Gunfighters808's topic in Pistols (Gas)
Any suggestions on where to get a PDI piston head? Had a look on google but can't seem to find one for the PX4.. -
Initial Impressions of the TM PX4 GBB Pistol
Krazeh replied to Gunfighters808's topic in Pistols (Gas)
Looking to replace the piston head in my PX4. Any recommendations? -
Would like to echo the above in terms of the customer service you get from BTC. Had an issue with my Spectre, exchanged a few emails with Frank to try and sort it out, but ended up having to return it to him for repair. Turns out there was an issue with both the upper and lower boards so he just replaced the entire unit. Absolutely no quibbles or arguments about it, Only asked that I paid to ship it back to him, he covered the cost of return postage. Couldn't have asked for better service.
-
Initial Impressions of the TM PX4 GBB Pistol
Krazeh replied to Gunfighters808's topic in Pistols (Gas)
Lost the front sight while playing so just looking to replace it. Stock would be fine, and I'm presuming would also be cheaper. -
Initial Impressions of the TM PX4 GBB Pistol
Krazeh replied to Gunfighters808's topic in Pistols (Gas)
Anyone know where I can get replacement sights for the px4? -
It's also going to be a lot easier to solder on some wires and a deans connector than try and get a mosfet installed. Sent from my Lumia 925 using Tapatalk
-
Initial Impressions of the TM SOPMOD M4 AEG
Krazeh replied to Gunfighters808's topic in Rifles (AEG)
Just buy some wire and a deans connector. Solder one end of wires to deans and other ends to the 'rods' already in the stock. -
Initial Impressions of the TM SOPMOD M4 AEG
Krazeh replied to Gunfighters808's topic in Rifles (AEG)
Tried eagle6? Altho i would strongly recommend going down the lipo route. If you can solder or know someone who can then it's a fairly easy, and reversible, mod to make. -
Initial Impressions of the TM SOPMOD M4 AEG
Krazeh replied to Gunfighters808's topic in Rifles (AEG)
Does anyone know where I can source a replacement stock tube? Everywhere I've looked either is out of stock or doesn't sell them. Cheers Nvm: turns out echigoya had one left in stock. -
So other than not getting it on the hop rubber is there any thing else in an aeg or gbb that you couldn't use froglube on? i.e. can you use it for your gearbox and the like?