Tommygunn

http://media.militaryphotos.net/photos/Spe...istan/hfrankssf

MM asks: 'ATTENTION! PLEASE DO NOT LINK DIRECTLY TO MY IMAGES - IT RESULTS IN MY BANDWIDTH ALLOCATIONS BEING EXCEEDED, AND MY PAGES GO DOWN. THANKS!'

Which is most faithful to the real steel?

Probably because it is a generic picture thread like all the others and the mods were concerned about all the clutter in stickie, which is meant for more important or essential viewing. It's not as though the thread is going to disappear from the top rankings. http://www.arniesairsoft.co.uk/forums/inde...howtopic=121776

It might sound a bit daft, and not to take anything away from a fine looking helmet, but I think it makes it look fussy in a way.

Someone binned my Crane stock guide in Technical. This problem pops up every week near enough.

Why did you cut the corners off your Velcro?

Simply the fact it does not fit the pistol grip and is not symmetrical. Why is there grip sticking out beyond the pistol i.e. below the hammer/backstrap area?

I have.

Do American cars still explode/burst into flames whenever they crash or go over a cliff, or have they improved the safety in recent years?

Looks just like some places in the UK.

Go here and I'll help you out. Just give me a quick run down on how far you've got so far. http://www.arniesairsoft.co.uk/forums/inde...howtopic=120852

Looks very cool.

What's the story with the bolt carrier and piston?

Original 80's? I remember they were the bike of bikes back in the day. Never had one myself but was forever looking at their shininess in the catalogues.

How about putting your red dot on straight so you can adjust the sights properly.

What happened?

Your question should be in technical. If your fuse is blowing then you have a motor height problem or a shimming problem, in either case something is binding.

Radio aerial mounts & gubbins.

Medic, Why have you got headphone brackets mounted on the Mich 2000?

I'm pretty sure the lugs, per se, don't have anything to do with barrel removal since it is very exposed, prone to accidental operation and probably has more to do with a sighting/accessory system. Where does the grenade sight mount to? Could it be a locator for that? Reason I say this is that if you look at various pics with the lug removed, or not, there are two(countersunk) Allen/Torx bolts which go through the receiver and engage with the breech block area of the barrel. They say it takes about five minutes to swap barrels, which makes sense, so presumably you need your tool kit with

Take it to technical, plus do some searching.

Small flat jewellers screwdriver or a thin walled tube inserted into the plug. Both will bend the two bards and allow you to pull the wire and metal plug free. Put some pulling force on the wire as you do so.

Why not do the sensible thing and phone the customs enquiry line? http://www.cbp.gov/

Yep, as you say, I've moved the top pockets to the arms and the lowers to the chest. When it comes to position of the arm pockets, I have the top corner positioned 7.5cm, in-line, from the end of the shoulder seam with the front edge intersecting with the elbow patch's top front corner.