sxheero

Thanks for the heads up, Completely forgot about the flashhider threads! I cannot get this thing off... at all... would you suggest the boiling water method? Would my receiver be okay if I dipped the whole frontend in boiling water (up to the barrel nut threads)? Please give me a hand guys, any suggestions would help!

Hope I can get some help here - I'm currently attempting to swap out the short barrel of my G&P Sentry to that of a standard m4 length. Ive got the fake gas tube and sight off no problem, but now I'm stuck I have the laylax armorer's wrench and I cannot get the barrel nut off... does it come off by twisting counter-clockwise or clockwise? Are there any little tricks like heating it up with a hairdryer? I bought the longer barrel thinking this would be an easy swap, but no such luck I bought a Madbull 14.5 Noveske outer - I hope this is going to work! Any help is gr

Just bought a used G&P Sentry (Black) Magpul Lower... so excited!! It arrived in excellent external condition and came with the following mods: SHS 7 metal tooth piston short-stroked by 2 teeth, an XYT bevel gear (the G&P one only had 2 ARL notches which was annoying, so I replaced it) a 3034 Mosfet with 25a HunterSeeker Armories Polyfuse. Systema bucking and element H-Nub installed Haven't bought the battery yet, but I figure I will run a 7.4 rather than an 11.1 in order to maintain some durability. Very excited to compare this gun to my KWA SR-10, Marui CQB-R (which has the best

I just spent about 3 hours reading through this topic as I am the new owner of a Magpul PTS Masada. I see that a number of you have had the same issue that I have regarding the hop-up shooting to the left or the right from the factory. However, I could NOT find a solution to this. Could somebody Please please please tell me how to correct this or direct me to a page where I can find this? I have no idea what to do. Thanks so much for your help and I apologize if I am beating a dead horse.