F1refly
Members-
Content Count
10 -
Joined
-
Last visited
About F1refly
-
Rank
Member
Additional Information
-
Airsofter since
20
-
Country
Nothing Selected
-
Yup, you said you didn't want the added strain on the motor. I personally used the wii tech nozzle, didn't bother with the chamber. TK4235's suggestion seems better since the nozzle is the most important part, there's a massive compression loss in that area, specially when the grease they put on there thins. At that time, I was only able to find the wii tech nozzle/chamber combo.
-
mod the air nozzle so you can add an oring or buy the wii tech nozzle/hop up chamber set.
-
http://www.filairsoft.com/forum/showthread.php?t=64545 Its from a forum, not sure if they sell online. Theres a number there too somewhere. Its the 12th pic from the top.
-
Just found out that there are some stores in the Philippines are selling complete gearboxes, costs around $ 95.00. Basically solves our need for spare gearboxes and you get a replacement microswitch, spring guide, and motor cage.
-
Yup, I agree... I was able to test it more now. I can consistently hit with the stock barrel compared to the edgi 6.01. If its 6.03 then its set, I thought I kinda remember some ppl getting 6.08 with theirs.
-
whats the inner diameter for the stock barrel again? Using an edgi 6.01 and it curves to the right, cant seem to correct it no matter what. went back to stock barrel, its shooting ok.
-
I'll look into this, tyvm
-
Yes, it is heavily modified. The only parts that are stock are switch assembly, spring guide, gearbox, hop chamber and tappet plate. The other parts are: 1. Silver wire with a DiY basic mosfet. Tried a fire control mosfet and the gun gets seizures on auto. 2. SHS 18:1 (stock ratio) gears 3. Wii tech air nozzle. Changed its o-ring with a viton 1mm x 5mm. The default was slightly thinner and felt it wasn't sealing properly specially with the stock cylinder head. 4. Modify standard V2 cylinder head, removed the impact rubber and replaced with toolbox's sorbo pad. Found this out by
-
Good day, newbie here. What spring guide do you guys suggest i use to replace the stock one? I would like to have a spring guide with bearing on my ACR. I can confirm that a standard Modify V2 cylinder head works. Been using it for a month now and have no problems. Gun is shooting 460 fps @ 30 rps w/ .2 bbs. Sweet gun