Oshiha

The foregrip is for carrying the AEG when I'm not shooting. Though I do think I need a shorter one

Not entirely matching but w/e. i'm on the right

Got better shots: First one is mine, second is my buddies. For anyone who cares, these were shot with a 5D Mark II, 24-70 lens.

Unfortunately no. The FPS max for any gun that isn't a bolt action is 425. Bolt actions have a max of 500 FPS.

My gun (the longer one) is electronically locked to safe-semi-3 round burst. I can run it full auto at about ~30rps, but I have it set up so that the 3 round burst is ~ 30rps. The shorter one is still safe-semi-auto

Me and my buddies custom M4's

Gun has awesome externals Gun has a VERY bad gearbox shell (can crack easily) The microswitch is horrible Compression parts could use changing Very easy to take apart

Without the ROF being dialed down, it clocks in around 33 bb/second.. which is an overkill IMO. I dialed down the ROF to 25 bb/second, with SAFE-SEMI-BURST (3 rounds). Before anyone asks why I went with 14.09:1 gears instead of 20:1 gears (would have gotten around the same ROF), well that just means the AEG is capable at pushing up to 33 bb/second if need be .

Gun is not quite done yet, but its been 3 months since I got the base gun! The parts list are: G&P Sentry Madbull Dragonfire 16" rail system G&P M16A2 stock G&P sniper grip Prometheus 455mm 6.03 TBB Prowin hop up chamber rhop + modify flat nub Modify piston Siegetek 14.09:1 single sector gears Lonex A2 motor Low-resistance wiring Extremefire Cheetah 2N mosfet and a 11.1v 3200mah 35C lipo

Gun is not quite done yet, but its been 3 months since I got the base gun! The parts list are: G&P Sentry Madbull Dragonfire 16" rail system G&P M16A2 stock G&P sniper grip Prometheus 455mm 6.03 TBB Prowin hop up chamber rhop + modify flat nub Modify piston Siegetek 14.09:1 single sector gears Lonex A2 motor Low-resistance wiring Extremefire Cheetah 2N mosfet and a 11.1v 3200mah 35C lipo

Air nozzle does not seal great, make sure to shim (as always), turn off the hop up when you swap barrels. The FET and electrical components are a tad iffy because of the lame microswitch. Don't run the gun in a very stressful setup or your GB shell will explode..

Nice.. What internals did you put in and what were the results? I'm looking to get the CYMA EBR as well

So the cheaper Masada has a better GB shell then the more expensive Masada? Thats funny. Good to hear for future Masada SV owners though.

Yep, I'll be running a Extremefire Cheetah 2N FET w/ Triggermaster software installed. The FET will reduce the rps to a stable 25-30rps. I will also be rewiring to low-resistance wiring, 16AWG wiring to handle the current.

I'm using a modify AUG piston without any modifcations