Yeager Posted July 20, 2007 Report Share Posted July 20, 2007 Dear Friends, I didn't know where to post this, so I just posted it in General Discussion. Recently, I acquired a G&G Lightweight MBK for my TM M16A2. Everything was going fine untill I put some electrical tape on the gun where the stock meets the lower. When I went to peel off the tape, part of the finish came with it! Lucky me, I had the correct paint* to repair the affected area. I tried the same on my other G&G bodied guns and received the same result. The most affected areas appear to be the rounded surfaces, edges, and inside the magazine well. Please, if you must wall mount your rifle take the time to cover your pegs in electrical tape. If you half *albatross* it like I did, you will end up with a nice square strip of finish missing on the *albatross* end of your lower! Thank you for your time, Yeager *(For Reference, the correct colour used on the receiver was "Killz Satin Black", For the stock G&G guns LR300, GR16, ect I've found that "Krylon Semi Flat" is the best match. ) Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.