RockDog Posted September 9, 2008 Report Share Posted September 9, 2008 Hi all. Ive just built my first Sig P226 into a guarder frame and was going well till I put the slide onto the frame. When the slide lock is in the normallocked position the slide won't sit in its normal position. It stops just a few mm out. When the slide lock is down it is fine. I have some pics to show where its sitting. Can any one help? Also whats the best grit sandpaper to rub down the inside of the mag well so the mag will no longer scrape? Thanks in advance Nick Link to post Share on other sites
Passonar Posted September 9, 2008 Report Share Posted September 9, 2008 Try 300+ grit paper. Cant help you with the mechanics through a keyboard though. sorry :/ Link to post Share on other sites
BrooklynBorn Posted September 10, 2008 Report Share Posted September 10, 2008 If you can, then maybe sand down the actual notch in the slide that hold the slide back. Make it larger. See if that works. Link to post Share on other sites
RockDog Posted September 10, 2008 Author Report Share Posted September 10, 2008 Thanks guys I will give it a whirl Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.