Mike_West Posted March 3, 2009 Report Share Posted March 3, 2009 Exactly, this thing here: http://www.uncompany.com/pageproductdetails.asp?prodid=9049 Sadly, UNCo doesn't have it in stock and Leonard is apparently out of Japan, but if someone can help me with this thing, I'd be glad. Link to post Share on other sites
James Kelly Posted March 6, 2009 Report Share Posted March 6, 2009 I'll latch onto this thread, as I too am in need of this exact same part. Specifically the screw that holds the two halves together. The MP5 magazine catch uses the same screw, so if someone could point me in a direction that would help me to locate the PSG1, G3 or MP5 part, I would be very appreciative, as I have been looking all over creation for one for months. Link to post Share on other sites
Kingmob3 Posted March 6, 2009 Report Share Posted March 6, 2009 The part for the PSG1 is the same as any other G3 magazine catch, you should be able to order it through a CA dealer. The screw is 4306-k from hillman fastner. You can find it at ACE, use a bit of lock tight. KM Link to post Share on other sites
James Kelly Posted March 7, 2009 Report Share Posted March 7, 2009 Does that mean that it needs loctite to stay in? That the screw does not mesh properly with the threads? Link to post Share on other sites
Kingmob3 Posted March 24, 2009 Report Share Posted March 24, 2009 sorry for being out there, the screw does mesh with the threads, locktite will just keep you from loosing another... KM Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.