Jump to content

Archived

This topic is now archived and is closed to further replies.

wilekcmc

Real Sword Type 97B

Recommended Posts

Guy's, I want to fit an infected armoury MOSFET to my type 97 b. I stripped the gun down at the weekend as I want to replace the wiring and keep the original loom as a spare. My problem is the wiring appears to incorrect but yet working fine! The positive terminal on the motor is wired to the negative wire on the battery! Is this normal for a real sword? Should I wire up the MOSFET exactly as per the original wiring with the positive terminal on the motor wired to the negative input on the MOSFET or wire up as per the infected armoury diagram?

Share this post


Link to post
Share on other sites

After cleaning up my t97 and replacing the piston, I decided to see how much of a difference in wear and tear with the 97B. I must say i was surprise to see everything is going well and the piston does not need replacing. Don’t know if this because i use a 3 round burst instead of full auto. Here are some pics for you all, and yes this is my primary weapon last season.

post-66130-0-61160600-1328616424_thumb.jpg

post-66130-0-42815500-1328616442_thumb.jpg

Share this post


Link to post
Share on other sites

Mod for the type 97 and 97 b

Cut out the small tab of plastic inside the handgrip at the top and you can then easily fit a 7.4 1300 lipo or 11.1 1100 lipo in the handgrip

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.