Jump to content
KTcerberus

AR15 Variants and Derivitives Picture Thread

Recommended Posts

Kingdong, do you have any QD suppressor to put on your M4? I'm planning to build a RIS II upper for my ino M4 as well, would love to see one with suppressor.

 

Whoring opportunity detected!

 

SDC10470.JPGSDC10475.JPG

 

 

I don't have any without the M203, and I sold my suppressor, but you get the idea. Here's a real one--unfortunately I lost the fullsize version but maybe someone else has it:

 

images.jpg

Share this post


Link to post
Share on other sites

Well here's my M4 again.

 

The 10.5" barrel was two piece and the grub screw finally stripped, so the barrel had so much wobble that it was unusable. I put the original in and replaced the DD Omega 9" for a CA 7" KAC RIS for the Block I look. It's really comfortable and fun to use right now. I'm awaiting Troy sights, the rear of which will be used on this rifle, and a G&P Aimpoint.

 

I loved having my rifle in a CQB setup, but I think I'll wait and buy a Block II upper down the road and use this as a general rifle, possible a DMR if I choose to put a tightbore all the way to the end of the can.

 

photo4cl.th.jpg

photo5xs.th.jpg

Share this post


Link to post
Share on other sites

Changed the M4 up a lot.

 

img5237q.jpg

img5239l.jpg

 

 

Now the question is if I should dust it all in Khaki.

Edited by Leon Kennedy
  • Like 1

Share this post


Link to post
Share on other sites

Too much deserty stuff around here for my tastes, plus an excellent whoring opportunity for my recently tarted up baby. ;)

 

 

l.jpg

  • Like 1

Share this post


Link to post
Share on other sites

Aye, there is a pool where I'm living temporarily. Silver lining and all that. ;)

 

 

You know full well I don't do tan. I leave that to everyone else on site. ;)

Share this post


Link to post
Share on other sites

You know full well I don't do tan. I leave that to everyone else on site. ;)

 

So you have a pool but don't have a tan ? You must use quite the high rated sun blocker :P

Share this post


Link to post
Share on other sites

OD Lower, black upper.

 

Thought I'd go with the Magpul / MW2 style 2tone, but in OD instead of tan.

 

2tone EOTech too, cause I got carried away.

 

Like/dislike? Anything you think would look better?

Share this post


Link to post
Share on other sites

Slu, is that a tan XPS or did you just paint it and add a tan EOLAD? Where did you get it from? So far, I've only seen black XPS's and EOLADs.

Edited by Section 8

Share this post


Link to post
Share on other sites

Actually, I think that might be the real deal...

 

http://www.opticsplanet.net/printable-eotech-exps3-extreme-xps-red-dot-sight-with-side-button-qd-lever.html

 

Haven't seen an airsoft version of one of these before. Very nice.

 

Yes it is the real deal, good eye! I got a pretty good deal on it in exchange for a 553 I previously got for a SOPMOD II carbine. AFAIK, 553s are being replaced by the tan EXPS "SU-233B/PEQ," as the laterally mounted battery copes with recoil better, not that it matters in airsoft. It works the same, just smaller and the buttons are on the side so you can sit a magnifier closer.

 

The throwlever is also tension adjustable. The 553 was loose on the Inokatsu upper (but was fine on RS and Prime uppers, there goes "in spec," Inokatsu), but the EXPS mount is tension adjustable.

Share this post


Link to post
Share on other sites

*snip*

 

Gimme my *fruitcage* shotgun back you *suitcase*.

 

 

 

 

 

 

Also, nice SFW's abbadon, it's nice to see some that aren't battered about and painted :P

Edited by hwagan
  • Like 2

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.