Jump to content

Two Stage CO2 Regulator Rig


Recommended Posts

For sale:

 

Two stage CO2 regulator set-up.

 

Stage 1:

Palmers Pursuit Shop DIrect Stabiliser + gauge (0-1200psi)

CCI 12grm CO2 Bulb Quick Change Adaptor

 

Stage 2: Palmers Pursuit Shop Boulder Low Pressure Regulator with Gauge (0-160psi)

 

All fittings and hose, with a QD fitting for between the mag and the regulator.

 

Also comes with a ring mount to attach the stabiliser to a 20mm weaver rail.

 

 

 

 

Please note, you will have to drill and tap your magazine with this set-up. I'll try and find the correct tap for it (10/32) if I recall.

 

Getting the information together and sourcing this was a bit of a nightmare, so all the hard work has been done for you.

Cost me about £250 by the time I got it here from the States.

 

Looking for £150 +postage.

 

IMG_0791.jpg

 

IMG_0793.jpg

 

IMG_0792.jpg

 

N.B. the 12grm bulb in the picture is an empty, and for reference only.

 

 

Cheers all.

Rob.

Link to post
Share on other sites

P1000584.jpg

 

The 2nd Stage was fitted underneath the Scope. Obviously, the application will probably need to be modified to suit your own particular set-up. That's a DSR-1 if you haven't gathered.

I have seen these attached to rails that are incorporated as part of the scope mounting system too.

 

 

 

There is no shut off valve in the system, I think you can get non-return valves that are a push fit onto the hose.

I didn't need it for my application, as the DSR ran on individual clipper strips so there was never any need to remove the hose from the magazine.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.