Probotector Posted March 16, 2013 Report Share Posted March 16, 2013 Finally! Too bad they won't ship oversea because I want one so badly. Airsoftmegastore - http://www.airsoftmegastore.com/8119-430-FPS-Elite-Force-SL9-SD-Electric-Blowback-Airsoft-Sniper-Rifle-AEG-w-Fully-Licensed-H-And-K-Trademarks.aspx Godfather Airsoft - http://www.godfatherairsoft.com/H-K-SL9-p/4375.htm Airsoft Atlanta (even cheaper) - http://www.airsoftatlanta.com/H-K-SL9-Elite-AEG-p/66617.htm (Btw. I'm not endorsed by any of these retailers. Also please excuse if this has been posted before or in the wrong section) Link to post Share on other sites
ollie_ty Posted March 16, 2013 Report Share Posted March 16, 2013 Entirely the right section, Good shout dude.Hopefully they'll be releasing those B&T handguards soon! EDIT: Probo if you get one, be sure to install a MOSFET if you intend to use high voltage/discharge bateries, otherwise the contacts in the trigger switch ( i dont like calling it a microswitch as its not really a surface mount microswitch) will arc and you'll have to keep scraping the rust off the contacts. EDIT 2; Bit drunk, lots of spelling errors. Link to post Share on other sites
Probotector Posted March 16, 2013 Author Report Share Posted March 16, 2013 Entirely the right section, Good shout dude. Hopefully they'll be releasing those B&T handguards soon! EDIT: Probo if you get one, be sure to install a MOSFET if you intend to use high voltage/discharge bateries, otherwise the contacts in the trigger switch ( i dont like calling it a microswitch as its not really a surface mount microswitch) will arc and you'll have to keep scraping the rust off the contacts. EDIT 2; Bit drunk, lots of spelling errors. Yeah, the only two concerns I have are the microswitch and the gearbox shell. I usually run 9,6V NiMh so I should be fine (the switch in my Masada is still working). I was planning on turning the full-auto mode into a 3-round burst so I won't get around a MOSFET (don't know which one yet) + 13:1 gearset and fitting motor. Since you own an ARES, how is the gearbox shell holding up? Link to post Share on other sites
ollie_ty Posted March 16, 2013 Report Share Posted March 16, 2013 Lol, Its fine, because its been out of action almost as soon as I bought it beccause it didnt like the 7.4v LiPo I was using, and I had to clean the contacts of the trigger. After I did that, I decided I wouldnt get it up and running until I'd intalled a MOSFET to protect them! But ,Mine will only be 350FPS and lower, so I doubt I'll have issues. Link to post Share on other sites
swatti Posted March 20, 2013 Report Share Posted March 20, 2013 Wish there were even one maker that dumps the fancy adjustments for a properly huge battery-space that stock could have... Also, Ares mentioned and no haters have attacked... Odd. Link to post Share on other sites
Horsem4n Posted March 20, 2013 Report Share Posted March 20, 2013 Umarex no longer works with ARES, all of their ARES type guns are made by S&T. still not that good build wise, but at least they arent giving ARES money. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.