TeamGoFast Posted January 29, 2015 Report Share Posted January 29, 2015 Long story short I reworked my RS L1A1 and had my Israeli wood furniture left over. I headed off to the hardware store and bought some all thread, nuts, bolts, washers, and some tube. Brazed a nut onto the end of the threaded rod. Twirled it around on a grinder to clean it up some as well as tapered it so it would get sucked into the reciever. What I did next was cut the tube to length, and bolted the stock on. Screwed on my home made butt plate because at the time (2012) I couldn't find a source for the Israeli butt plate. I already ran a router through the origional stock hole to use a swivel from a Rhodesian stock. The handguards required a small bit of bending of the rear mounting tang. And that's how you put wood onto your Chinese FAL clone. Link to post Share on other sites
Imperator Posted January 30, 2015 Report Share Posted January 30, 2015 It looks really good! Good job! Link to post Share on other sites
bettyblue84 Posted January 30, 2015 Report Share Posted January 30, 2015 Always nice to see custom stuff, good job. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.