Jump to content

Prowin IPSC Magazine Gas Routers


vilerk

Recommended Posts

Anybody know where to find replacements?  Both of mine have a chunk missing at the same place..  I've already emailed Prowin to no avail.   

DSC_0166_zpsnlyqedkh.jpg

It's possible to convert them to use standard routers, with some 1mm thick rubber sheet and silicone RTV, since the gas output hole is 2mm backwards compared to TM spec, which explains the proprietary gas router.  However this way will most likely end up in restricted glass flow, so I'm not looking forward it to it.   

Another option I was thinking of was to make a mold from the original and cast them, but since the supplies will run close to $80, I was wondering if this is a common issue among the Prowin mags and if anybody would be interested in buying some?  

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.