ninja828 Posted April 2, 2017 Report Share Posted April 2, 2017 So I recently purchased a Bullgear hop up unit for my A&K 249 but was gifted a while back a ZCI barrel w/ a fitted rhop for another project that I never finished. I was wondering if anyone else had run this hop up unit w/ an rhop sucessfully? Link to post Share on other sites
Horsem4n Posted April 3, 2017 Report Share Posted April 3, 2017 I set up my friends A&K M60 with a flat hopped bullgear and ZCI setup. Has had it for around 6 months and I haven't heard from him that it hasn't worked well yet. Link to post Share on other sites
ninja828 Posted April 3, 2017 Author Report Share Posted April 3, 2017 I set up my friends A&K M60 with a flat hopped bullgear and ZCI setup. Has had it for around 6 months and I haven't heard from him that it hasn't worked well yet. How were you able to remove the hop arm as I've read the pin for the arm was more or less impossible to remove? Link to post Share on other sites
Yoroiden Posted April 3, 2017 Report Share Posted April 3, 2017 I use a vice and a small punch. Link to post Share on other sites
ninja828 Posted April 4, 2017 Author Report Share Posted April 4, 2017 I use a vice and a small punch. Did you end up installing M-nubs too? Or did you just something like the Namazu flat hop nub? Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.