Jump to content

Archived

This topic is now archived and is closed to further replies.

evilrobotshane

F2000 mag catch causing misfeeding

Recommended Posts

Yesterday, my G&G F2000 (Mister Splashy Pants) started misfeeding on all magazines, the workaround being to shove and hold the magazine further up into the magwell. I opened her up when I got home and found that the cradle where the pivot point on the mag catch sits has broken, so it isn't holding the mag catch as high up as it needs to be.

 

I have a few bad ideas about how to fix it, but no good ones. An essential part of a gun's plastic body breaks no isn't too uncommon in airsoft though, so I figured somebody might have some pointers on how to get it working again.

 

post-69994-15027072337419_thumb.jpg

Share this post


Link to post
Share on other sites

It is, yes. Steel powder mixed into the epoxy, so it tends to set a lot harder and in my experience, lasts a lot longer than most of the other stuff out there. Had a friend use it to repair a cracked cylinder on his motorbike engine, held up fine for the rest of the month til his next payday.

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.