druid799 Posted September 24, 2017 Report Share Posted September 24, 2017 Bought my self an Odin speedloader (saw one and was very impressed by it) BUT as you all know basically all it'll load are 5.56 stanag mags unless you buy some ridiculously expensive adapters , so decided to make my own . Took a knackered old hi-cap cut it down to size cut away a fair bit of the old feed tube from the inside and then got one of those little speedloaders tubes you get with pistols that get binned straight away , cut it too size , big dollop of epoxy , chunk of packing foam to compress against the mag to be loaded to stop it sliding around and job done ! Now I do have to say I'm sat here with smug face as it's cost me nothing to make and after testing , it's loaded P90/MP5/M14/G36/Sterling mags all flawlessly! Well chuffed with it . Link to post Share on other sites
DarkLite Posted September 24, 2017 Report Share Posted September 24, 2017 And here I am designing a 3d-printable one. Bums. Link to post Share on other sites
druid799 Posted September 24, 2017 Author Report Share Posted September 24, 2017 Sorry matey , but I'm sure yours will be a lot prettier than mine ! Link to post Share on other sites
DesertFoxRomel Posted December 23, 2017 Report Share Posted December 23, 2017 Neat. I was thinking of doing the same thing, but with that speed loader tube you mentioned and a big glob of epoxy putty for the body of the adapter. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.