Jump to content

!HELP! TM 5.1 safety/slide pin problem


mang

Recommended Posts

Ok...weird problem. I am installing an SD SV Infinity metal slide onto my Marui Hi-capa 5.1. I took the factory blowback piece and installed it onto the new slide and shaved down a little off the rear slide tracks on the lower frame right near the hammer. My PROBLEM IS THIS: when you put the slide pin and everything back together, the decocked position is with the slide to far back. This makes it impossible to engage the safety when the hammer is down. Looking at it, I noticed the lower frame slide pin hole and hop-up slide pin hole does not match up when it should. Instead, it eclipses too early when the slide decocks. WHAT IS GOING ONE!!! I tried putting the blowback piece back into the stock slide and now I have the same problem there! I can't figure this out. PLEASE HELP!!!

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.