BigRedJ Posted November 18, 2006 Report Share Posted November 18, 2006 ok i'm replacing a few psrt on ymy M4 but i have afew questions. 1) Removing the Deltaring / Outer barrel there are 4 spring pins, but how to get then out? you cant pull them, do you just tap them into the barrel, are they short enought to fall free? 2) Sliding stock ok the screw on the bottom or the back of the body drops the whole stock off. but how do you get the stock off the tube? any dissasembly help is appreciated also of you take the lower gearbog out, do you need to pull the fire selector out first? does it just pull out? ta for the help Link to post Share on other sites
CerberusCO Posted November 19, 2006 Report Share Posted November 19, 2006 To remove the LE stock, pull the adjustment rocker all the way to the stop, then pull the stock off. Link to post Share on other sites
blue_5 Posted November 19, 2006 Report Share Posted November 19, 2006 Dont need to remove the fire selector (at least in the 2006 model, but i assume its the same for pre 2006 ones as well) to remove the lower box. Link to post Share on other sites
cazboab Posted November 19, 2006 Report Share Posted November 19, 2006 1) Removing the Deltaring / Outer barrel there are 4 spring pins, but how to get then out? you cant pull them, do you just tap them into the barrel, are they short enought to fall free? <{POST_SNAPBACK}> You're barking up the wrong tree there mate, what you do is take the upper receiver and hop unit/ inner barrel out, pull back and twist the delta ring so it lines up with the two notches and can slide down the barrel, now twist the barrel nut(the bit the spring sits on) loose by wrapping a tea towel around it and turning it clockwise if you're holding the gun the right way around(IE pointing in the direction you'd be shooting) then the barrel pulls out and off 2) Sliding stock ok the screw on the bottom or the back of the body drops the whole stock off. but how do you get the stock off the tube? <{POST_SNAPBACK}> Like CerberusCO said, you pull the tab straight out from the stock instead of levering it. also of you take the lower gearbog out, do you need to pull the fire selector out first? does it just pull out? ta for the help <{POST_SNAPBACK}> No but you do need to remove the pistol grip(take out the two screws on the baseplate, disconnect and remove the motor, take out the two screws inside the grip) and the Magazine catch( screw in the middle on the button). After that set the selector to semi pul the trigger very slightly and pull the gearbox out. Link to post Share on other sites
BigRedJ Posted November 19, 2006 Author Report Share Posted November 19, 2006 cheers guys, thanks for the help i'll give it a go in a bit see its allways good to ask before atempting anything! the expoded fdiagrams in the manual only tell you so much Link to post Share on other sites
BigRedJ Posted November 19, 2006 Author Report Share Posted November 19, 2006 great stuff, done it all, thanks guys, now i just have to put the hopup bucking in, joy.... Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.