Cyber Soldier Posted December 23, 2007 Report Share Posted December 23, 2007 I am in love all over again Link to post Share on other sites
-FIDO- Posted December 23, 2007 Author Report Share Posted December 23, 2007 Are you going to engrave the proper selector markings? no, not really problem is that they are stamped in, and i would need to remove somehow the old ones and make new ones.. i dont want to mess around too much an risk fu*** up the receiver and finish because of such a small thing.. Link to post Share on other sites
FW200 Posted December 23, 2007 Report Share Posted December 23, 2007 Is that the same reason you're not doing the "RPK" bulges at the front of the receiver? Link to post Share on other sites
-FIDO- Posted December 23, 2007 Author Report Share Posted December 23, 2007 jop Link to post Share on other sites
my_plague_666 Posted December 23, 2007 Report Share Posted December 23, 2007 ever thought of trying to replicate the original pistol grip by adding onto the AK74 grip with epoxy or something? Link to post Share on other sites
-FIDO- Posted December 24, 2007 Author Report Share Posted December 24, 2007 not really, but thats a thing i could try for real if i mess it up i can easy replace the grip Link to post Share on other sites
dookieboy Posted December 27, 2007 Report Share Posted December 27, 2007 Hrm, is their anywhere I can get a replacement barrel if I screw up on thinning out the barrel for RS gas block, fron sight, and rear sight blocks? Also FIDO, for fitting the RS Rear sight block if you just are going to use that only, do you just need to thin the barrel like everything else? Thanks! Link to post Share on other sites
-FIDO- Posted December 27, 2007 Author Report Share Posted December 27, 2007 hm replacement barrel? you could try and ask ting from RMW if he can find them, but best is not to screw it up... just make it thinner, and test fit every 3 seconds also if its too thin, use bit of tape, and in the end when you make the thread and screw it on, there should be no wobble at all... you just need to mod the end part of the barrel, the sight block will slide all the way back, wo probs the gas block went on wo any mods on the barrel the frontsight was a PITA, but its doable Link to post Share on other sites
dookieboy Posted December 28, 2007 Report Share Posted December 28, 2007 Thanks FIDO, gunna be ordering *praying* so I can get the guarder kit, then buying a spare barrel just in case. Link to post Share on other sites
-FIDO- Posted December 28, 2007 Author Report Share Posted December 28, 2007 you're making a m70? Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.