cjfield1129 Posted December 2, 2007 Report Share Posted December 2, 2007 The gun is the Kart/Echo M14 EBR. Has anyone experienced similiar problems in the below weakspot? The grip and stock only connect to the frame via a single large allen bolt. The grip is tight but there is wobble when a minimun amout of force is put on the sliding stock. Any ideas? Link to post Share on other sites
Dat1Guyx342 Posted December 2, 2007 Report Share Posted December 2, 2007 You may want to mention if that is a Kit or Echo/Kart replica. Link to post Share on other sites
ianhaz Posted December 2, 2007 Report Share Posted December 2, 2007 My pistol grip on the kart was a bit wobbly, not the bit your talking about but the join between the pistol grip and the chassis, all i did to correct it was tighten the screws. You should be able to do the same, just tighten all the screws and liberally apply threadlock and it should stay together Link to post Share on other sites
Silas5150 Posted December 3, 2007 Report Share Posted December 3, 2007 If you want you can remove the gb from the chasis to inspect it. I did this after my brother's Echo 1 EBR was experiencing "forward and back" play and I found that where the bolt meets the receiver the metal was cracked. We're going to epoxy it later this week and see if it holds up any better. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.