Jonny Posted June 10, 2008 Report Share Posted June 10, 2008 As the titles says, I've been trying to remove the feed tray cover on my A&K M249 but it doesn't look obvious at all how it all comes apart. I dont wan't to break my baby so I hope somebody here can shed some light on this so I can install my railed feed tray - Jonny Link to post Share on other sites
master_titled Posted June 10, 2008 Report Share Posted June 10, 2008 You have to punch the pin out. Simple as that. Link to post Share on other sites
Jonny Posted June 10, 2008 Author Report Share Posted June 10, 2008 Gah, I was doing that and it didnt budge and inch and I was afraid of snapping something, but here goes! You have to punch the pin out. Simple as that. Link to post Share on other sites
master_titled Posted June 10, 2008 Report Share Posted June 10, 2008 Hmm... well then, is the feed cover perpendicular to the gun? You should be able to push part of it out by hand then use a screwdriver. Link to post Share on other sites
Jonny Posted June 10, 2008 Author Report Share Posted June 10, 2008 Ah ha, turns out there is a c-clip I never saw that was holding the pin in place! Pop that sucker off and the pin slides out perfectly Link to post Share on other sites
master_titled Posted June 10, 2008 Report Share Posted June 10, 2008 Well there you go, that explains it... Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.