Lone_Bullet Posted October 12, 2009 Report Share Posted October 12, 2009 As I'm changing my outfit, I'm changing the AEG! Looking for a nice VFC SCAR-H FDE I have a black light one ( Mk16 ), in mint condition. This one has a fully ( to my likings ) upgraded gearbox/motor which I'd like to keep, so if you're interested, please keep your gearbox and motor as wel I include the following accessories: - Hopup with stock CQB barrel and stock rubber/nub - Hopup with KM 6.04 barrel 365mm with Guarder clear hop rubber, Element black H nub - Hopup with RealSword Type 97 brass barrel ( seems quite accurate ), I *think* 420mm, Element RED V-rubber, Element White H nub. - VFC SV sniperbarrel extension ( fits the RS type 97 barrel perfectly! ) - VFC SCAR flashhider + SCAR silencer - some rubber rail protectors. Damage: the C-spring for the assembly pin in the front of the lower handguard is gone. The pin won't fall out though, you even need a screwdriver to knock it out! I carved a subtle + and - on the contact points where the stock meets the receiver, it is not visible when the AEG is assembled. Used 3 times to show off in a skirm, has not even seen 500 bbs through it! Shipping is EU only, Belgium preferably, but not necessary . Link to post Share on other sites
Lone_Bullet Posted November 8, 2009 Author Report Share Posted November 8, 2009 As I'm changing my outfit, I'm changing the AEG! Looking for a nice VFC SCAR-H FDE I have a black light one ( Mk16 ), in mint condition. This one has a fully ( to my likings ) upgraded gearbox/motor which I'd like to keep, so if you're interested, please keep your gearbox and motor as wel I include the following accessories: - Hopup with stock CQB barrel and stock rubber/nub - Hopup with KM 6.04 barrel 365mm with Guarder clear hop rubber, Element black H nub - Hopup with RealSword Type 97 brass barrel ( seems quite accurate ), I *think* 420mm, Element RED V-rubber, Element White H nub. - VFC SV sniperbarrel extension ( fits the RS type 97 barrel perfectly! ) - VFC SCAR flashhider + SCAR silencer - some rubber rail protectors. Damage: the C-spring for the assembly pin in the front of the lower handguard is gone. The pin won't fall out though, you even need a screwdriver to knock it out! I carved a subtle + and - on the contact points where the stock meets the receiver, it is not visible when the AEG is assembled. Used 3 times to show off in a skirm, has not even seen 500 bbs through it! Shipping is EU only, Belgium preferably, but not necessary . Sold, Admin might remove this ad. TY Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.