b1indsamurai Posted January 1, 2010 Report Share Posted January 1, 2010 Does anyone know if the MUR on the G&P Magpul/MUR receiver set is CNC cut? ehobby says so: http://shop.ehobbyasia.com/gandp-magpul-dx...oft-aeg-bk.html Can anyone verify this? Also, how does it compare to the Dytac? Link to post Share on other sites
bluntshooter Posted January 1, 2010 Report Share Posted January 1, 2010 i honestly dont think the upper is cnc cut, but i heard somewhere that the lower is straight from PTS since PTS makes them G&P spec Link to post Share on other sites
Pradal-Serey Posted January 1, 2010 Report Share Posted January 1, 2010 I had the dytac and the G&p, g&p is die casting not cnc. On the other hand the dytac is cnc'ed & hard coat but the old mur design can make problem with some front set Link to post Share on other sites
uscmCorps Posted January 1, 2010 Report Share Posted January 1, 2010 but the old mur design can make problem with some front set Only with LaRue style free floats. The DYTac is the Gen 1 style MUR, That said, it'll still work with LaRue Free Floats, you just can't use the LaRue anti-rotation clip. Link to post Share on other sites
Pradal-Serey Posted January 1, 2010 Report Share Posted January 1, 2010 With my Daniel defense rail too and troy mrf., I had to sand the tabs that were used as anti rotation Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.