Handsome Pete Posted March 15, 2010 Report Share Posted March 15, 2010 Bought 4 of these very cheap because they were not filling with gas. Ive stripped 1 down and found the ball bearing intact etc but the whole shell comepletely grease free. So Ive stuck silicon grease on the ball bearings and o rings etc. Still not filling. I'm gonna take the o rings off and drop them in some brake fluid (as suggested in the brilliant KA shell fix thread) http://www.arniesairsoft.co.uk/forums/inde...390&hl=40mm to get them to expand a bit. Is there anything else I could do? People with experience with these particular shells especially? thanks. Link to post Share on other sites
sir naggedalot Posted March 15, 2010 Report Share Posted March 15, 2010 Even though they are supposed to be self setting I found that on a couple of mine I need to push the firing pin all the way in to reset it. If the pin returns all the way back and is flush/level with the base of the shell it should be good to go. One of mine only had one ball bearing in it but was still working ok! If it resets with the pin not flush try twisting the body a couple of turns. Plenty of silicon grease is very much advised for these nades. Link to post Share on other sites
Handsome Pete Posted March 16, 2010 Author Report Share Posted March 16, 2010 Thanks for the info. Seems Catman's guide works on these too. Thanks alot. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.