xRAZERx Posted June 16, 2005 Report Share Posted June 16, 2005 How easy are these things to fit? Is it just a case of removing the handguards that you have and then putting the new ones in their place? Cheers, xRx Link to post Share on other sites
HaVoC Posted June 16, 2005 Report Share Posted June 16, 2005 Yeah, I've looked at them in BBT and they look to be straight replacements. There are thin wires connecting the switch up, so be careful not to catch that somewhere sharp, but it should be easy. Link to post Share on other sites
xRAZERx Posted June 16, 2005 Author Report Share Posted June 16, 2005 Cheers Hav *Razer goes back to AA* Link to post Share on other sites
Magsz Posted June 16, 2005 Report Share Posted June 16, 2005 Are you putting this on a TM or a CA? If you're putting it on a TM you're going to have to replace the middle section of the outer barrel with the one thats supplied with the m500 handguards. Its straight forward enough so i doubt you will have any problems doing it. PS, as havok said, the wiring in the handguard is exposed so i would highly suggest you put some electrical tape over it to prevent your battery from nicking the wires. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.