ED-SKaR Posted March 12, 2006 Report Share Posted March 12, 2006 i have a gearbox from a CYMA AK47, and after finding out that it can only handle a 6" barrel (rather than a 16" AK barrel) i am looking to make the whole thing smaller. my intention at the moment is to fit the gearbox into the shell of a springer MAC11 or micro/mini uzi. i require the following measurements. 1, length between the breach and the back of the gun (to compare to the length of the gearbox) 2, length between the top and bottom of the receiver (to compare to the height of the gearbox) 3, length between the left and right of the receiver (to compare to the width of the gearbox) 4, height between the bottom of the receiver and the height of the barrel (to find out at what level the gearbox must be) +1s will be rewarded, (even if i fail ) Link to post Share on other sites
Sledge Posted March 12, 2006 Report Share Posted March 12, 2006 Would it be easier if you just bought my springer UZI off me? I'll break out the tape measure later. Link to post Share on other sites
ED-SKaR Posted March 12, 2006 Author Report Share Posted March 12, 2006 UZI might be to big, i want to be able to holster this thing. however, you *might* have a deal measurements in inches please Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.