boardslide113 Posted February 7, 2005 Report Share Posted February 7, 2005 The threads on my G3sas spin like 90 degrees, is that normal? Link to post Share on other sites
Ledpocket Posted February 7, 2005 Report Share Posted February 7, 2005 If you're talking about the tiny outer barrel, then yes (based on the 2 g3 sas's I own). 1, you can just crank down on the setscrew (and repeat as needed) 2, you can figure out the sweet spot of maximum barrel tightness, and either file a little flat for the setscrew to bite into, or drill a little divot there, for the same effect. I reccomend #2 if you are at all mechanically inclined. I used the "drill" method, myself. My outer barrel is rock solid. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.