Jump to content
  • entries
    4
  • comments
    0
  • views
    812

TM 1911a1 problems


realsteel

269 views

Well yesterday i got a TM1911 being my usaual curious self i wanted to know how it worked so i opened up the frame and part GM1-46 fell out after an hour of figuring out where that part went in i finially got it in. Then not learning my lesson i opened up the slide. After takeing out the outer barrel and recoil springs out i desided to remove the blowback unit. First i unscrewed the back of it then i proceeded to prying it out, then some how a spring (GM1-15) got cuaght on the rear sight, the spring bended. When i finially got the blowback unit out i discovered the deformed spring then i proceeded to epirement and tape the top of gthe blowback unit so the spring would pop out.

Right now i just got done with putting a rubber o-ring into the valve of the TM 1911 magazine in an effort to save propane. I got the o-ring from a cheap $1.60 cigar lighter.

 

0 Comments


Recommended Comments

There are no comments to display.

Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.