darkchild130 Posted March 1, 2008 Report Share Posted March 1, 2008 So i have my madbull 6.03mm barrel and shark hop rubber ready and waiting, but i cant take the stock barrel out without fear of breaking something. Im a technical dumbass. I've got as far as seperating the upper and lower receiver and removing the gas tube assembly. I took the body screws out too as well as removing the rear sight, but the body wont come apart without looking like im about to break the hop unit. Im left with my stock inner barrel sticking out, defying me, filling me with rage. Please help!!! Darkchild Link to post Share on other sites
kie Posted March 1, 2008 Report Share Posted March 1, 2008 http://www.youtube.com/watch?v=pVbj5XAHMSw if that didn't help, i think there is a set of screws by the hop up, as far as i can remember just unscrew them all and it should slide out. Link to post Share on other sites
darkchild130 Posted March 1, 2008 Author Report Share Posted March 1, 2008 Ive already seen that video, it doesnt go into barrel takedown. Where are the screws by the hop-up exactly? Ive unscrewed everything i can find on the outside but it still doesnt seem to come apart easily. Darkchild Link to post Share on other sites
Rob15 Posted March 1, 2008 Report Share Posted March 1, 2008 You need to take the rear sight off and remove the screw under there and the one behind the mag well, then the body should separate iirc. The hopup unit is held in by a few screws which you'll need to remove as well as 3 on the barrel clip, you can then swap the barrel out. If the body isn't separating just give it a good yank (at your own risk), the hopup is only connected on one side so you'll have to be seriously ham fisted to break it. Link to post Share on other sites
kie Posted March 1, 2008 Report Share Posted March 1, 2008 as far as i can recall if you look at the hop up lever there should be one screw to its right. also one screw to its left holding the barrel grip in place. Link to post Share on other sites
darkchild130 Posted March 1, 2008 Author Report Share Posted March 1, 2008 Thanks guys, ill get to work on it now. Darkchild Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.