DangerWerx Posted March 13, 2011 Report Share Posted March 13, 2011 DangerWerx CQB Rocket Valve for the KWA Mp9 Do you own a KWA Mp9 Airsoft Gas Blow Back SMG? Do wish you could use it at your local CQB field, but cannot due to the gun shooting "too hot,” over the allowed limit? Well, now you can! with the DangerWerx CQB Valve! Just install this handy little plug and watch as your SMG's velocity drops 40-60 fps*. Allowing you to enjoy your MP9 replica anywhere you go!** These valves are CNC manufactured of high quality Aluminum in the USA. If you can follow instructions and disassemble your gun, you will be able to install this valve in no time!*** All you need is a Flathead screw driver, a small hammer and a small punch pin. Follow these take down instructions...Take Down Guide Written by Dobey If you do not feel confident in installing it yourself, you can support your local Airsoft tech and have them install it for you! Just be sure to show them the link. Afterwards, you can enjoy the use of your Mp9 or replica at any CQB Airsoft venue.** Here is a Test Video Firing off one magazine at 67*F http://www.youtube.com/watch?v=GopTyHFpXn4 Get your MP9 CQB Valve now for a limited time offer of $15.00 + Shipping. There are limited quantities, so hurry soon! The use of your Mp9 indoors can yours! * Your results may vary. Factors include ambient temperature, spring settlement and other various conditions. ** The Airsoft replica may be qualified for use under fps limitations; however, other variables may apply, so be sure to contact your local field for more information. *** DangerWerx is not responsible for improper installations or damages faced from installation of CQB Valve. The DangerWerx CQB Valve is intended and sold for aftermarket use only. The product is not intended to imply that this part is KWA original equipment or endorsed by KWA. The installation of any aftermarket part may void or otherwise adversely affect your factory warranty. It is the sole and exclusive responsibility of the user to determine the suitability of the product for his or her use. The user shall assume all legal, personal injury risk, and liability and all other obligations, duties and risks associated therewith. Link to post Share on other sites
DesertFox Posted March 13, 2011 Report Share Posted March 13, 2011 Are these the 330fps ones? Do you have any 300fps ones? Link to post Share on other sites
DangerWerx Posted March 13, 2011 Author Report Share Posted March 13, 2011 My production vavle flutes sit around 320-330 atm. I do have my prototype flute valve which was doing about 300-310 if you would like that instead. Link to post Share on other sites
Reppyboyo Posted March 25, 2011 Report Share Posted March 25, 2011 PM sent. Link to post Share on other sites
PianoBlack Posted April 12, 2011 Report Share Posted April 12, 2011 Will you be manufacturing MP7 valves? -Piano Link to post Share on other sites
DangerWerx Posted April 12, 2011 Author Report Share Posted April 12, 2011 The Valves are actually cross compatible between the mp9's and the mp7's. We figured if some people can use the old mp7 valves in the Mp9, and that the current run of mp7's and mp9's have a similar jet valve, the two would work, and they do. Not much improvement in the Mac11 though, but it is an open bolt gun. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.