Cire_ Posted February 20, 2016 Report Share Posted February 20, 2016 Hey guys. So i've upgraded about everything in the gearbox of a CA SVD including a NanoAAB mosfet and the only item i removed is the anti rev latch. Here is the trouble. The gun is from start only a semi only rifle, but i get full auto on it. And i can't quite make sure what the problem is that making it go full auto. It works well otherwise. Im using 11.1 lipo. Any tips? Link to post Share on other sites
swatti Posted February 24, 2016 Report Share Posted February 24, 2016 I'd put the anti-rev latch back. A powerful neo-magnet motor might keep it from spinning backwards but if for some reason it decided to do that and you pulled the trigger... Adios teeth. Did you swap out the gears and cut-off lever? Take the spring out, spin her without it, does it stop or just spin? Some replacement steel cutters are a bit low. I imagine it has non-proprietary cut-off? Some gearsets have low nub for the cutter too so it won't disengage the power. It may do it at low speeds when testing by hand but it slips when ran by the motor. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.