FUmiYAsu Posted December 20, 2004 Report Share Posted December 20, 2004 I am trying to get a stock for my sunproject M16 but I need some measurements. Could anyone tht has a ICS M4 measure the inner diameter of the stock and the length from the top of it to the goove? Oh, and the width of the goove. I've attached a photo of to show wht i mean.... PS: Please also tell me whether you have the ICS Le stock of "ICS M4s" or "Marui M4s" any help would be appreicated Link to post Share on other sites
RedDragon Posted December 20, 2004 Report Share Posted December 20, 2004 Here are the measurments for the ICS M4 LE Stock. I measured these with a tape measure. Hope these help you. RedDragon Link to post Share on other sites
Hissing_Sid Posted December 20, 2004 Report Share Posted December 20, 2004 ICS M4 c/w sliding stock. [edit] As RedDragon says, the bushmaster style stock on the ICS M4 has the hole closer to the top of the butt plate. Link to post Share on other sites
FUmiYAsu Posted December 20, 2004 Author Report Share Posted December 20, 2004 Thx...tht bit on the top shouldn't be a prob as long as it fits on the buffer tube....the only thing is tht I don't seem to be able to work out how to use the inch measurements on my tape measure...it's got 8 thingy for every inch, so ..... anyway, it seems tht the ICS one is 0.1 inch smaller than my one. ...don't think it will fit... do you know if this is bigger or smaller than the marui? Link to post Share on other sites
RedDragon Posted December 20, 2004 Report Share Posted December 20, 2004 Well you've got the .5 inch mark, the .25 inch mark, and the one before that is .125 because you divide the .25 by 2. Not sure if it will work. I know that the ICS M4's have a very hard time of accepting other stocks. Not sure if it is larger or smaller, never owned a Marui M4. RedDragon Link to post Share on other sites
Hissing_Sid Posted December 20, 2004 Report Share Posted December 20, 2004 And what was wrong with my measurements, in mm? Link to post Share on other sites
FUmiYAsu Posted December 20, 2004 Author Report Share Posted December 20, 2004 oh....didn't quite see it.... it's still small thou.... Link to post Share on other sites
RedDragon Posted December 21, 2004 Report Share Posted December 21, 2004 And what was wrong with my measurements, in mm? <{POST_SNAPBACK}> Lol. That works too. Just depends... Link to post Share on other sites
FUmiYAsu Posted December 21, 2004 Author Report Share Posted December 21, 2004 Does any of you have a Marui M4?, I actualy asked a friend to do it for me but you pple online are actually way faster than him.... Link to post Share on other sites
FUmiYAsu Posted December 22, 2004 Author Report Share Posted December 22, 2004 hey, you know tht bit tht has the width of 12mm yea, what is the height of it? thx Link to post Share on other sites
Hissing_Sid Posted December 22, 2004 Report Share Posted December 22, 2004 hey, you know tht bit tht has the width of 12mm yea, what is the height of it? thx <{POST_SNAPBACK}> 5mm Link to post Share on other sites
FUmiYAsu Posted December 22, 2004 Author Report Share Posted December 22, 2004 thx again Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.