Miker Posted June 5, 2007 Report Share Posted June 5, 2007 I have a hurricane hi-flow valve laying around and want to put it to use... How would I go about installing it? BTW it's for a G18c extneded mag. Link to post Share on other sites
davedawg123 Posted June 5, 2007 Report Share Posted June 5, 2007 You need a KSC valve removal tool or you can mod a screwdriver to mimic the shape. Link to post Share on other sites
Chris North Posted June 5, 2007 Report Share Posted June 5, 2007 I used a small screwdriver (3mm IIRC) at an angle and tapped the back of it to loosen the valve. I've never tried it on a KSC valve, but it should work if you can't get anything else. It's probably best to buy the removal tool though, IMO. Link to post Share on other sites
kal Posted June 5, 2007 Report Share Posted June 5, 2007 12 dollars for a specialist tool? bleh... can you not get a nice wide screwdriver and just dremel out the middle of it? though dremeling tool steel will probably cost you 12 dollars in cutting disks... Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.