lance201 Posted November 17, 2009 Report Share Posted November 17, 2009 Hello, I am trying to get my new MOE PTS Grip on my CA, but I am not able to get it right, there is always a gap between the body and the grip, nearly 2mm. Anybody else who encounter this with the MOE grip? Thx Lance Link to post Share on other sites
maverick343432 Posted November 17, 2009 Report Share Posted November 17, 2009 Strange, my Moe grip was a perfect fit on my CA. Is the motor sat right? Link to post Share on other sites
lance201 Posted November 18, 2009 Author Report Share Posted November 18, 2009 The gap is there before the motor is in, btw. what should the motor have to do with it? I have to fasten the grip at the gearbox first... Lance Link to post Share on other sites
Abelius Posted November 18, 2009 Report Share Posted November 18, 2009 Sure the wires aren't getting mashed between? I had a CA gearbox once that couldn't fit any other but the original CA grip. The screw holes were simply misaligned. Hope yours isn't like that. Link to post Share on other sites
Magsz Posted November 18, 2009 Report Share Posted November 18, 2009 Make sure the bevel gear bearings are not grinding or binding on the motor grip. Link to post Share on other sites
lance201 Posted November 18, 2009 Author Report Share Posted November 18, 2009 Sure the wires aren't getting mashed between? I had a CA gearbox once that couldn't fit any other but the original CA grip. The screw holes were simply misaligned. Hope yours isn't like that. I checked the wires...and yes there is a small Prob with the screwholes, but this is not the reason for the gap... I will try another grip. Lance Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.