renegadecow Posted February 26, 2015 Author Report Share Posted February 26, 2015 Kitchen floor omitted. Link to post Share on other sites
MEHall Posted January 10, 2016 Report Share Posted January 10, 2016 Sorry if this is a bit late but i recently fount this thread! Is there any description of how you made that stock holster? Link to post Share on other sites
renegadecow Posted January 11, 2016 Author Report Share Posted January 11, 2016 See first post. Link to post Share on other sites
Deve Posted January 11, 2016 Report Share Posted January 11, 2016 The ones being sold in HK are for HFC but will probably fit Tercel and KWC just the same. Can confirm they fit Tercel and Denix replicas, so if it's Broomhandle shaped and not grotesquely out of proportion, they should fit. Link to post Share on other sites
MEHall Posted January 11, 2016 Report Share Posted January 11, 2016 Ok but there are no measurement and you dont say what size there are on the hinge and on the screws you use. The measurement inside i can figure out but not the screws used on the hinge and the lock for the stock lid! Besides of that it's a great how to. Link to post Share on other sites
renegadecow Posted January 11, 2016 Author Report Share Posted January 11, 2016 I'll put up some dimensions within the week. As for the hinge, it's just a plain 2 1/2" door hinge with wood screws. Link to post Share on other sites
MEHall Posted January 11, 2016 Report Share Posted January 11, 2016 Nice! This do it your own is suerly great as an original Mauser C96/m712 stock holster is very expensive, often much over £ 150. And with all measurement it's suerly going to be a very good DIY description for all that want a cheaper stock holster for their Mauser pistol. Have a nice time with your stock holster. Link to post Share on other sites
renegadecow Posted January 20, 2016 Author Report Share Posted January 20, 2016 Here are the dimensions. It's the same one as before, just recolored darker. Link to post Share on other sites
MEHall Posted February 4, 2016 Report Share Posted February 4, 2016 That is perfect! But i must say i got a perfect deal on a stock/holster from a member here. But nevertheless it's very good that all the measurements are there as it actually eases the fabrication of the stock/holster, Link to post Share on other sites
paranoiddroid Posted February 29, 2016 Report Share Posted February 29, 2016 What are you planning for the mounting system to use as a holster? Link to post Share on other sites
renegadecow Posted March 1, 2016 Author Report Share Posted March 1, 2016 Me? Nothing fancy really. I built it for my French resistance/post apocalyptic loadouts so just looping some cord around the neck of the stock and the lanyard loop of the grip is fine with me. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.