What Type of Motor?

[-=OGGY=-]

For my Noveske project, I decided I want to use this box:

http://www.intrudershop.com.tw/show_produc...roduct=1059#top

 

(I would be using one of the larger springs)

 

Anyway, I was wondering if I should use a Bore-UP or High-Speed motor(or whatever)

 

I want to use all Guarder parts. Any advice would be great. - Thanks, OGGY

 

 

[cderamos]

My recommendation is the Guarder SP110 spring, Guarder Revolution, and 10.8v NIMH or 11.1v LIPO Battery.

Personally I built a setup using:

Classic Army New version Cylinder set (aluminum piston head)

Classic Army bearing guide

Action 7mm Bearings

Guarder High Speed Gears

Guarder SP120

Guarder Revolution

9.6v 4500mah NIMH battery

 

445fps and 23-25rps right now.

[crablegs]

Get the fps numbers out of there please.

 

Go for a guarder infinite torque.

[T.P.Evan]

Good old TM EG1000 will do the job just fine...that's what I'm currently running with RPS near the mid-twenties. I've even had an EG700 spit out 20-22 RPS at a consistent 390fps on a 10.8V 4200mah NiMH.

[-=OGGY=-]

Thanks for the replys; what spring would I use w/ the Guarder box and Guarder Infinate Tourqe up motor to get around 328 fps (It's ok if it's not exact since i'm in the US) -Thanks, OGGY

[crablegs]

Ok, so you want 1 joule and you live in the U.S? Well for 1 joule I would just save some $ and get a TM or CA motor, the guarder would be too much at that fps even with an 8.4volt battery. Get a guarder sp100 and take any bearings off spring guide and piston head.

[-=OGGY=-]

Well I was going to find out what the 1 joule was and go 1 step higher only because I know we are not supposed to disscuss fps over 328.