Jump to content

Archived

This topic is now archived and is closed to further replies.

Fin

Basic tanaka revolver cylinder disassembly

Recommended Posts

I was asked how to do this but i couldn't explain it in words. So i decided to take some pictures on how to do it, but instead of just sending them to him i'll stick up this basic guide. Its nothing complex but if your like me you like to know what your doing and a small contingent of pictures is always helpful.

 

This is from a smython but i imagine the design will be very similar on the other models

 

Step 1, remove these 3 screws (Dont lose them or your ******)

cy1.jpg

 

Sometimes the plate will just pop off but sometimes it wont, if yours does not then carefully pry it off by putting a small flat headed screw driver through the gas fill hole and simply pry it off (dont press on the fill value, rotate the cylinder a bit first)

cy2.jpg

 

Step 2, With the plate off it should look like this. There is a small spring inside (which shouldn't eject itself), take this off and put it with your screws (dont lose this either) From here you can remove the fill in value by unscrewing it anti-clockwise with a flat headed screw driver

cy3.jpg

 

Step 3, i had no idea what to call these parts but basically this is disassembling the rest of the cylinder and separating the gas part from the revolving part ;) .

Grab the front bit with a pair of pliers while holding the 'L' shaped part and unscrew as in the picture, your need the pliers as the seal is quite hard at the start.

cy4.jpg

 

With everything disassembled it should look like this

cy5.jpg

 

To get to the last rubber 'o' ring you have to unscrew this part (anti-clockwise), inside you will find a thin rubber o ring and a spring. I dont want to take this apart as i dont want to damage the o ring, unscrew and pull it out slowly so you can see how it comes apart.

cy6.jpg

 

Next clean everything, re-silicone and replace anything damaged then re-assemble. All pretty easy to do

 

If you need any more help let me know and i'll help you if i can

 

 

Not responsible if you break anything and so on...

Share this post


Link to post
Share on other sites
Nice guide, wil be useful when I get myself a 29 Metal kit. Can you do one on how to remove the inner barrel aswell?l

 

I would but i dont own the revolver anymore :( If i remember right there is a small screw right above the barrel which you have to undo, and its a bit fiddly

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use and the use of session cookies.