Tek-Spec Posted October 17, 2006 Report Share Posted October 17, 2006 Does anyone know how to remove the white trades of a CA M15? Im thinking i would prefer a totally blank body, the trades are white and i want them off without leaving a trace they were there? Tips please, Thanks. Link to post Share on other sites
Tom Andrews Posted October 17, 2006 Report Share Posted October 17, 2006 As long as they weren't engraved onto the body, and only silk screened, try white spirit. It may take a little time, but usually it will work without damaging the paint beneath. Link to post Share on other sites
[ VX ] Posted October 17, 2006 Report Share Posted October 17, 2006 Problem is..markings are laser eteched on..meaning, they leave a small indent. I wonder, if you could use a form of putty over this (only small ammount) and resprayed receiver. Downside..it's extra work AND it'd have to be hardwearing putty, otherwise it'd be a bad bass for paintjob. Link to post Share on other sites
Tek-Spec Posted October 18, 2006 Author Report Share Posted October 18, 2006 Thanks, Yes they are etched on, I was hoping there would be a way to just rub them off (as Tom above said) and have a clean look. The putty idea sounds good but might be a bit challenging for me. If you see anything more on removing them let me know. Thanks Again Link to post Share on other sites
juicymeat Posted October 18, 2006 Report Share Posted October 18, 2006 Well if you like the idea of camo painting your gun for functionality, that would be an easy and beneficial solution. Link to post Share on other sites
maverick343432 Posted October 18, 2006 Report Share Posted October 18, 2006 Or Krylon the whole thing black Link to post Share on other sites
jonarthur Posted October 18, 2006 Report Share Posted October 18, 2006 how about abit of car body filler ? then just use some glass paper to sand it down then spray it ... Link to post Share on other sites
Tek-Spec Posted October 18, 2006 Author Report Share Posted October 18, 2006 Good ideas, im trying to avoid sanding and spraying but it seems the only option. I will look into krylon. Thanks for the tips Link to post Share on other sites
screamin_weasel Posted October 18, 2006 Report Share Posted October 18, 2006 i think doc newstead removed the trades on his. try pm'ing him. i might be wrong though. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.