[BS]_MARS Posted November 26, 2007 Report Share Posted November 26, 2007 All you Gunkote (paint) users, do you have to bake the stuff on? I'd like to use some Gunkote FDE on a helmet but if you've got to bake it then I doubt it'll be much of a helmet afterwards... Link to post Share on other sites
snorkelman Posted November 26, 2007 Report Share Posted November 26, 2007 Ive baked it on is pretty tough stuff when done like that Only ever tried it on an old scrap barrel when it came to testing it for air drying - it took a while to dry and had no real adhesion to it Link to post Share on other sites
[BS]_MARS Posted November 26, 2007 Author Report Share Posted November 26, 2007 Well, I'm not out to get it to stay on forever, just wondering if you must bake it on or if it acts like Krylon when its just sprayed and left to dry. Link to post Share on other sites
maccrage Posted November 26, 2007 Report Share Posted November 26, 2007 Ive baked it on is pretty tough stuff when done like that Only ever tried it on an old scrap barrel when it came to testing it for air drying - it took a while to dry and had no real adhesion to it So, sounds like it flakes off if you look at it without baking. Link to post Share on other sites
[BS]_MARS Posted November 26, 2007 Author Report Share Posted November 26, 2007 Got it. I don't know why I missed that. Link to post Share on other sites
sekiryu Posted November 26, 2007 Report Share Posted November 26, 2007 Do you actually throw whatever it is that you've painted into the oven? Link to post Share on other sites
chas Posted November 26, 2007 Report Share Posted November 26, 2007 AFAIK, there is a "bake on" Gunkote series and an "air cure" series. The oven series will hold up a lot more, but you cant bake your plastic AEG parts (or helmet). Both series work with some plastics and I bet our replica plastics are not made of those Gunkote works on well. Use Duracoat if you must. Link to post Share on other sites
snorkelman Posted November 26, 2007 Report Share Posted November 26, 2007 aye 150 degrees C preheat them first so they're nice and warm spray a few very light coats the heat will help them flash off a little then a slightly heavier coat and back in oven again Obviously while other half is out of the way (though we never actually use the cooker so its kinda academic lol) Link to post Share on other sites
dr_pepper_lover_airsoft Posted December 17, 2007 Report Share Posted December 17, 2007 i coated a barrel with it, had it baked at a local + friendly garage infront of their very hot floor heaters Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.