Matthias

Hey all. I am in the process of upgrading my TM P226 with a metal barrel, however it is causing troubles with the hopup chamber. As you can see from the pictures, the little tab that helps hold everything in place is sliding across the metal outer barrel and getting a channel scratched into it. This seems to happen because the outer barrel does not correctly hold the inner barrel while cycling, allowing the inner barrel to "fall out" a bit as can be seen from the second picture. Does anyone know how to prevent this from happening? Any help would be appreciated. Pictures:

Add heat. There is commonly some glue that holds it on. I got mine off by putting a lighter on it for a bit and then using pliers (or a hand in a glove) to twist it off.

Hey guys, I hear a lot about TM mags being compatible in WE 226's and KJW 226's, but does the reverse hold true? Specifically, does the WE P226 magazine fit the Tokyo Marui P226? I assume it does. If so, is there a noticeable difference in performance? I would go with a TM mag but they are unfortunately difficult to come by in the USA at the moment and with shipping from HK, they are about twice the price of a WE/KJW mag that can be found domestically.

Has anyone tried to increase the strength of the trigger spring? The one thing I don't like about my TM is that the pull on the trigger is so light/sloppy. Would it be as simple as using a thicker wire spring? or would that cause unforseen troubles?

What part of the trigger is "dummy"? It is still SA/DA.

Are the triggers and magazines compatible between the E2 and Regular Marui P226's?

I have a quick question for you guys: I am looking at getting a KWA USP from someone second hand, however he is unsure if it is NS2 or not. How can you tell the different between the two by looking?

Well done Chaoslord

Hmm. That sounds like a good idea. Thank you.

It happened with both nozzles actually, I should have mentioned that. Although I just got it chrono'd today, I figure 405 fps with 120 and a .25g isn't too bad. I guess I have a good seal.

Hey guys, I need some help with a feeding problem I am having with my CA G36k. My setup: CA G36k ProWin Hopup Chamber Madbull blue bucking SHS Airseal nozzle. Private Parts M4 Magwell adapter And a sector chip The mags I am using to test this are King arms M4 Midcaps and a Tokyo Marui Hicap. Here's the fun bit: Both mags feed flawlessly with the addition of a spacer between the hopup chamber and the gearbox. This spacer is only .3mm thick However, without the spacer, the TM mag misses one shot every 5 or 6 and the KA mags fail to load about 1 of every 3 shots. A

1987 Chrysler Fifth Avenue. Not really a good picture (all I had was my cell).

Keeping it simple