Wutang

Shot of the cylinder+piston rails inside a gearbox?

More pics of my MEU:

More pics of my MEU:

Thanks! The grip is a tight fit, but it should slide right on with no modifications.

I got myself into the KJW club about two months ago and finally got enough funds to finish my build: KJW GBBR M4 Cradle Airsoft velocity reducer, tightbore, and BCG extension Madbull JP Rifles flash hider ACM m900 weaponlight and Eotech xps-2 Ready-mag spraypainted tan Magpul FDE MBUS, CTR stock, MOE grip, rail covers, trigger guard, and BAD Lever.

I got myself into the KJW club about two months ago and finally got enough funds to finish my build: KJW M4 Cradle Airsoft velocity reducer, tightbore, and BCG extension Madbull JP Rifles flash hider ACM m900 weaponlight and Eotech xps-2 Ready-mag spraypainted tan Magpul FDE MBUS, CTR stock, MOE grip, rail covers, trigger guard, and BAD Lever.

I got myself into the KJW club about two months ago after stumbling on this thread and finally got enough funds to finish my build: KJW M4 Cradle Airsoft velocity reducer, tightbore, and BCG extension Madbull JP Rifles flash hider ACM m900 weaponlight, Noveske 10 inch rail, and Eotech xps-2 Ready-mag spraypainted tan Magpul FDE MBUS, CTR stock, MOE grip, rail covers, trigger guard, and BAD Lever.

I think it counts?

Thanks! I also did a ton of DIY tweaking (helps performance just as much if not more than the upgrades themselves) to get the gun shooting exactly how I wanted it to. End results: 400 fps +/- 1 fps, low 30s rps, more than 200 foot effective range (Haven't really tested groupings yet, but this is the range where I can consistently hit people in skirmishes).

Ding Ding! Fresh out of the wash too.