-FIDO- Posted October 13, 2006 Report Share Posted October 13, 2006 up!! the hu bucking works trough this hole Link to post Share on other sites
Atomic Posted October 13, 2006 Report Share Posted October 13, 2006 I added a 509mm (Aug) tightbore innerbarrel to my G36 and a 363mm (M4A1) tightbore barrel to my MP5 (they run thru the silencers). I believe both have increased in accuracy. Link to post Share on other sites
GuzziHero Posted October 13, 2006 Report Share Posted October 13, 2006 up!! the hu bucking works trough this hole <{POST_SNAPBACK}> Unless its a P90 Link to post Share on other sites
renegadecow Posted October 13, 2006 Report Share Posted October 13, 2006 I fitted a 6.04 tightbore to my CA M15a2...hardly any difference, if any at all. In fact, Ive been hugely disappointed by ALL of the internal mods Ive made. I wait to see if the 1J spring has made a difference (was firing at 290fps) <{POST_SNAPBACK}> the "leap" will be more considerably felt if you use a 2J spring. Link to post Share on other sites
GuzziHero Posted October 13, 2006 Report Share Posted October 13, 2006 Which...would be a little impractical with the UKs 1J limit... Link to post Share on other sites
Sledge Posted October 13, 2006 Report Share Posted October 13, 2006 Could someone tell me where exactly in America this myth of barrel length affecting accuracy comes from? Link to post Share on other sites
Xaccers Posted October 13, 2006 Report Share Posted October 13, 2006 Could someone tell me where exactly in America this myth of barrel length affecting accuracy comes from? <{POST_SNAPBACK}> Sniper rifles are very long egro long = accurate Or something like that I would imagine. Link to post Share on other sites
Wraith18A Posted October 13, 2006 Report Share Posted October 13, 2006 Could someone tell me where exactly in America this myth of barrel length affecting accuracy comes from? <{POST_SNAPBACK}> Its got something to do with their penis size. I think they stole a glance at yours, however, because we've all seen the internets conversation you had with Senator Foley, Sledge. Link to post Share on other sites
Glenn Posted October 14, 2006 Report Share Posted October 14, 2006 The myth of a long barrel = accuracy likely comes from the real steel world, where a longer barrels create greater velocities and flatter trajectories. Saying this idea is confined to America is about as stupid as anything else Sledge says. I personally think a longer barrel in airsoft may permit a BB to stop or slow it's bouncing in the barrel before it leaves. That assumes a BB bounces in the barrel, which it might not, and it assumes that the additional contact between the BB and the barrel doesn't increase bouncing. It's really just my guess, though, and I don't think a longer barrel is ever going to make much of a difference beyond 6-7-8 inch lengths. Barrel and BB quality are the keys to accuracy in my experience, as is a good consistant hop. A longer barrel will increase lock time, though. Link to post Share on other sites
renegadecow Posted October 14, 2006 Report Share Posted October 14, 2006 Which...would be a little impractical with the UKs 1J limit... <{POST_SNAPBACK}> Oh yeah But at least thats one way I could confirm that longer and tighter barrels do make a difference. Around here, open sites go way beyond forum limits and this is where adding a longer /tighter barrel counts. So the whole concept turns into baloney if you live in UK. Link to post Share on other sites
Erestheux Posted October 14, 2006 Report Share Posted October 14, 2006 STUPID AMERIKA U GUYZ SUK AMIRITE?! *ahem* So uh, its not too useful to get a longer barrel on anything longer than a P90, but what about the "vented" cylinders that Hissing_Sid mentioned, like the Mp5k? This is confusing. I've always thought "precision" barrels were most likely not that great, too. But probably have a lot more effect on shorter barrels rather than longer ones. Maybe I will end up getting a tighbore for the MP5k... Link to post Share on other sites
1911 Posted October 14, 2006 Report Share Posted October 14, 2006 A quick question. What happen if a BB passes through a rifled barrel? Would it work? I know that some people says it wont work because BB needs presurized air in the barrel to fly. I'm curious as to how the BB would react until some tests have actually being done. Just a thought. Link to post Share on other sites
chas Posted October 14, 2006 Report Share Posted October 14, 2006 What about longer barrels and distance archieved? Link to post Share on other sites
WizardofAirsoft Posted October 14, 2006 Report Share Posted October 14, 2006 Is there possibility that a tightbore barrel with a 1J spring would actually push the gun over the UK limit in FPS? Link to post Share on other sites
slacky Posted October 14, 2006 Report Share Posted October 14, 2006 A quick question. What happen if a BB passes through a rifled barrel? Would it work? I know that some people says it wont work because BB needs presurized air in the barrel to fly. I'm curious as to how the BB would react until some tests have actually being done. Just a thought. <{POST_SNAPBACK}> There are 'rifled barrels' around made by Tanio Koba, for example see here the only piece of info I could find was from another forum saying The idea was to use a very slack twist (I don't think the shorter barrels even had a full twist in them) to spin the air in the barrel, but as it was only a slight twist the BB itself wouldn't spin. The cunning idea was the spinning air would keep the pressure constant all around the bb as it flew down the barrel thus keeping it central in the barrel, so it didn't touch the sides and giving a better more consistant flight. which is the most sense i got out of the threads ive read on this subject. Is there possibility that a tightbore barrel with a 1J spring would actually push the gun over the UK limit in FPS? <{POST_SNAPBACK}> possibly as thier are claims of massive fps boosts by tightbores(30+), dunno if this is b/s or not. Mine achieved something like +12fps - altho this increase could of been put down to the new hop rubber installed aswell. Link to post Share on other sites
Glenn Posted October 14, 2006 Report Share Posted October 14, 2006 Is there possibility that a tightbore barrel with a 1J spring would actually push the gun over the UK limit in FPS? <{POST_SNAPBACK}> Of course there is. Tightbore's usually increase FPS at least a little bit, so if you're shooting at 327, a tightbore will put you somewhere mildy over the limit. Link to post Share on other sites
Skarclaw Posted October 14, 2006 Report Share Posted October 14, 2006 Of course there is. Tightbore's usually increase FPS at least a little bit, so if you're shooting at 327, a tightbore will put you somewhere mildy over the limit. <{POST_SNAPBACK}> A tightbore will put my fps mildly over 381/2 fps? Link to post Share on other sites
Glenn Posted October 14, 2006 Report Share Posted October 14, 2006 What are talking about. The UK/Arnies limit is 328. If you are approaching that limit, a tightbore, by permiting less air to escape around the BB, will raise your FPS to greater than 328 FPS. Try keep up, dear. Link to post Share on other sites
Skarclaw Posted October 14, 2006 Report Share Posted October 14, 2006 UK limit is 381/2. The arnies limit is 328. When you were discussing the UK limit, you said that a tightbore would put a 327 gun midily over the UK limit, thus, over 381/2 fps. Thanks for the neg rep though. Link to post Share on other sites
Glenn Posted October 14, 2006 Report Share Posted October 14, 2006 Quoth the rules: Airsoft Muzzle Velocity discussion ("the 1 Joule Rule") Discussion of Airsoft replicas that shoot BBs with more than 1 Joule of muzzle energy is not tolerated. While the 1 Joule limit is not a legal limit defined by UK law, it is legally considered that any Airsoft replica at this limit or below, cannot cause a penetrative injury to a person. This means that the law considers any replica shooting above this limit as either a grey area, or a weapon. As we want this sport / hobby to remain safe, discussions of power levels (or equipment that will enable a replica to exceed this power level) is not allowed. We understand that in many countries, velocities of 400 feet per second and more are legal, but this is a British web site, with a British owner and we have set this limit for discussion as it helps to ensure that all members stay on the right side of British law. Semantics aside, 1J is ALWAYS considered the limit here. Link to post Share on other sites
PariahWolf Posted October 14, 2006 Report Share Posted October 14, 2006 As much as I dislike Glenn. I agree with him here. Link to post Share on other sites
Skarclaw Posted October 14, 2006 Report Share Posted October 14, 2006 If you are talking about the "UK limit", people will think you are talking about the "UK limit" not the arnies limit or such. Link to post Share on other sites
1911 Posted October 14, 2006 Report Share Posted October 14, 2006 There are 'rifled barrels' around made by Tanio Koba, for example see here Thanks for the link. Very COOL!! Now how do i fit that into my WA GBB? Link to post Share on other sites
PariahWolf Posted October 14, 2006 Report Share Posted October 14, 2006 If you are talking about the "UK limit", people will think you are talking about the "UK limit" not the arnies limit or such. <{POST_SNAPBACK}> BY far the majority of sites in the UK set their limit at 328. I understood what he meant. Link to post Share on other sites
BCPneumatics Posted October 15, 2006 Report Share Posted October 15, 2006 Here is my theory on why some people get better accuracy, and some don't: First, the length of the barrel (to a point) increases the accuracy of the gun. In guns with longer barrels, the BB has possibly already reached it's 'maximum accuracy', therefore a tight bore has little to no effect. In guns such as MP5's, with shorter barrels, the tightbore helps compensate for the inadequate barrel length, so there is an improvement in accuracy. Also, correct me if I'm wrong, but rifling doesn't do jack for a spherical projectile that has backspin. (Actually, it would make it less stable in flight, wouldn't it?) Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.